Awning Ledger Board

Step 4 attach an 8 foot metal l shaped ledger to the house and to the ledger board using 1 inch screws.

Awning ledger board.

So make a mark above 7 to 8 inches and keep a minimum gap of 2 inches at one of the ends. Also you need to keep enough open space approximately 3 4 inches above the top of the mounting bracket and ledger board. The placement of the ledger header determines the level of the roof so be sure it is positioned at the correct height and is horizontal. The brackets are then lag bolted to the roof and sealed watertight.

Hammer a 1 by 4 by 8 ledger board on the exterior wall of the house using 16 penny nails. Never install a ledger board over the top of siding no matter what you hear this can weaken the connection. The ledger should be attached before the foundation is built for a deck patio roof posts and other structure. Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.

Find the wall studs or roof trusses that will have to support the ledger. In order to install the ledger board you usually need to remove the house s siding. Any one of these five ledger connection methods properly installed will give you a reliable long lasting deck that is secure. Where to attach a patio roof ledger.

Note you will need a minimum of 3 of unobstructed room above the top of the mounting bracket and ledger board for the awning to fit properly this measurement increases to 4 with a. Make it the full width of the porch or slightly wider depending on your porch design. A ledger header board is the first step if you are attaching the patio roof to an existing structure. The ledger typically a 2 by 6 is usually designed to hold one end of the patio roof rafters.

Minimum of 7 6 from the deck or patio to the top of the mounting bracket and ledger board. The roof top brackets wood ledger board and lag bolts are to be purchased locally by customer. Make sure the nails go through the wall studs. The awning should be at least 7 to 8 feet above the ground or the patio.

Locating and mounting the ledger is normally a fairly easy process. This is a time consuming process and should be done while the house is being constructed to simplify the process and reduce costs. Locate a position for a header or ledger board. Five ledger board techniques explained and illustrated.